guitar plus pedal Voodoo Lab Pedal Power 2 PLUS 8-output Isolated Guitar Pedal Power Sup – Drugan's Drums & Guitars
SKU: 41732232768
guitar plus pedal

guitar plus pedal Voodoo Lab Pedal Power 2 PLUS 8-output Isolated Guitar Pedal Power Sup – Drugan's Drums & Guitars

$25.55 $28.39
Save 10%
No.2 Bestseller on parroquiadesanalbertomagno.com >

Pay in installments of $7.10 with ShopPay, AfterPay and Klarna

Shipping Estimate
USA
  • USA
  • CAN

Ships within 48 hours · Estimated delivery Jul 6 - Jul 11

Promo Codes Available:

For Your Every Summer RSVP, with Code: SUMMER15

Description

guitar plus pedal Voodoo Lab Pedal Power 2 PLUS 8-output Isolated Guitar Pedal Power Sup – Drugan's Drums & GuitarsFor your kind consideration is this Voodoo Lab Pedal Power 2 PLUS 8 output isolated guitar pedal power supply. It is in excellent condition and has been tested and works as it should. It comes with 5 18" 2. 1mm right angle standard polarity (PPBAR R), 1 24" 2. 1mm straight to right angle standard polarity (PPBAR RS24), 1 2. 1mm right angle to 3. 5mm right angle standard polarity mini plug (PPMIN R), and 1 18" Voltage Doubler double 2. 1mm to a single

For your kind consideration is this Voodoo Lab Pedal Power 2 PLUS 8-output isolated guitar pedal power supply. It is in excellent condition and has been tested and works as it should. It comes with 5 - 18" 2.1mm right angle standard polarity (PPBAR-R), 1 - 24" 2.1mm straight to right angle standard polarity (PPBAR-RS24), 1 - 2.1mm right angle to 3.5mm right angle standard polarity mini plug (PPMIN-R), and 1 - 18" Voltage Doubler double 2.1mm to a single 2.1mm standard polarity (PPY) cables and the IEC power cord. Enjoy!

Pedal Power 2 PLUS is the most dependable and widely used guitar effects power supply in the industry, delivering legendary performance to a wide variety of devices from sensitive vintage battery-powered stomp boxes to modern DSP effects. The 2 PLUS is equipped with eight galvanically isolated 9V outputs, including six outputs switchable to 12V, two 250mA outs for more power-hungry effects, and two outputs featuring a SAG function that simulates the output of a low battery. 18V and 24V operation is also available by combining outputs with available special cabling. A handy onboard 200-watt courtesy outlet is included for powering an additional device such as an AC-powered effect, wireless system, or another power supply. Pedal Power 2 PLUS is ideal for small to medium pedalboards or as a supplemental power supply in a larger rig. 

*All orders may require a signature at time of delivery unless discussed prior to shipment.

*International customers will need to pay actual shipping cost if amount is greater than estimated shipping charge shown. In many cases, international shipping may be less than price shown. Please contact us with your country and postal code prior to purchase if you need a shipping quote, and we will send an offer with exact correct shipping charges.

Shipping Notes
  • Free Standard Shipping on $100+ Orders to the USA.
  • Except Preorder products are shipped in 48 hours.
  • Delivery to the USA:
  1. Standard Shipping : 3-10 business days
  • If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
  • We offer a 30-day return/exchange service after receiving.
  • Final sale items are not eligible for returns or exchanges.
  • To process your return/exchange, please contact us at [email protected]
  • Please click here for more details>>> Return & Exchange Policy
SKU: 41732232768

Discover Niche Categories That Outsell guitar plus pedal

Top-Converting Item to Boost Your Average Order

4.1 ★★★★★
Based on 1404 reviews
Sort
Highest Rating
Newest First
Oldest First
Product Reviews
S
Verified Purchase
S
Grantham, US
★★★★★ 5
Comparison with POTAUTO filter: Very similar but cheaper
I bought a POTAUTO MAP 1033C and EPAuto CP846 cabin air filter to compare them for use in my 09 Legacy (gen 4). They both seemed comparable and are cheaper than most other, similar filters, though the POTAUTO was and still is ~33% more expensive than the EPAuto. Both seem built well-enough, considering they're only being used as relatively low-flow cabin filters. That said, the EPAuto is slightly better, mainly due to the white trim piece being unattached along one side on the bottom of the POTAUTO filter. Almost certainly nothing that will affect its performance or longevity, but it is interesting considering it's the more expensive of the two. However, it must be kept in mind that this is an incredibly small sample size. In one of my very scientific tests (/s), I held them up side by side and looked through them toward the sun (obviously being careful) to judge thickness/density and uniformity. Neither had any thin spots that I noticed, and they were pretty similar overall. One of them blocked slightly more light than the other, indicating more filtration, but I unfortunately don't remember which one. I feel like it was the EPAuto, but I don't really want to speculate as I could very well be wrong. What I do remember is that the difference was so minor that all else being equal, it wouldn't justify the cost difference between the two. In other words, even if the POTAUTO were the slightly better one, it wouldn't be worth the extra few dollars for the minimal amount of extra filtration. In another test, I compared the filters to each other and the old filter (which I'm pretty sure was OEM, but certainly not a charcoal filter, so it was significantly thinner) by blowing air from a compressor through them. I held the nozzle at roughly the same distance from each on one side of the filters, and I held my other hand at roughly the same distance from each on the other side. The old filter, unsurprisingly, let much more air flow through. Both charcoal filters were much more restrictive due to their extra thickness, leading me to feel much less air coming through. Both were roughly the same. Both filters also held up just fine to the strong blasts of air. I bought a couple other filters that I was going to cut to fit to use one or both with these filters as a pre-filter and/or additional charcoal layer. After the airflow test, I decided against this, as these are a lot more restrictive than OEM already, and I didn't want to push it, since that could at best cause issues with getting good airflow into the car, and at worst could damage the blower. If not for the fact many, many people have been using these and similar filters for a long time without apparent issue caused by this, I would hesitate to even use these. I haven't noticed a decrease in the airflow, but it's doubtful I would since I rarely turn the fan up past the first couple settings (usually have it on the first) if I have it running at all, and I have the center vents pulled out (to access the inside of the dash) which causes the flow at the vents to be reduced slightly. TL;DR - Both the POTAUTO and EPAuto charcoal filters appear to be a good choice, with the EPAuto having a slight edge on build quality (based on my limited sample size of one each) and a cheaper price. Filtration appears to be very similar between the two, certainly not enough of a difference to warrant the extra price for the POTAUTO over the EPAuto. Flow is significantly more restrictive than OEM filter but doesn't appear to be an issue. I give the EPAuto 5 stars and the POTAUTO 4 stars, only because the value of the POTAUTO is a good bit less (very similar or possibly even inferior quality for 33% more money). I can't speak to their longevity or performance, but I don't imagine either should prove to be an issue. -------------------------------------------------- As a side note relating specifically to the Legacy: replacing the cabin filter in this car is a PITA. It's not overly difficult per se, but a serious pain and certainly not something you're going to do when you have a spare few minutes. I'd rate it probably around a 3.5/10 in difficulty and a 7/10 for annoyance. While you can sort of access it by removing the manual compartment, you can't remove the tray through that. So you need to actually take the whole glove box out, which requires removing the side panel, unhooking the string/loop that keeps it from falling all the way down, and removing a few plastic screws, which can be a bit of a pain (and apparently Subaru loves them since they're all over the car). A stubby Philips driver will be helpful. Once you have the glove box out of the way, you have to unscrew several more of those plastic screws to remove the plastic cover between the glove box and the filter. This hole is where you gain access. Be careful when removing the old filter as loose dirt and debris may fall out and make a bit of a mess. You don't really want to get any in the fan below it if you can help it. Reverse the steps to reassemble it, and remember to reattach the string. Getting the glove box back in its track can be a bit of a challenge; in my experience from doing it multiple times I've found you sort of half force it and half don't. That is, it'll likely offer some resistance even if it's lined up, so if you try to baby it you'll probably be there a while, but also play with the alignment a bit to see if you can get it without marring up the tab and the slot on the right side too much. All in all, expect to spend anywhere from 15-45 minutes on this, and make sure you have a standard length as well as a shorter or stubby Philips screwdriver. I have to say, when it comes to air filters, this car is horrible. The air intake filter is a pain to change, too--much worse than most if not all other cars I've done. -------------------------------------------------- Keywords: Subaru Legacy, fourth gen, fourth generation, 4th gen, 4th generation, 03, 04, 05, 06, 07, 08, 09, 2003, 2004, 2005, 2006, 2007, 2008, 2009
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on September 29, 2017
R
Verified Purchase
R
Pawtucket, US
★★★★★ 5
Good price on the part and 5 min install saved me $35
Fit fine in my 4th gen 4Runner took 5mins to install
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 19, 2026
M
Verified Purchase
M. Clark
West Palm Beach, US
★★★★★ 4
Fit 4runner
Fit my 05 4runner. Good product
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on August 2, 2025
W
Verified Purchase
WTG
West Palm Beach, US
★★★★★ 5
Great price!
I love that I can order these on Amazon for less than half of what I would pay at the mechanic. They fit perfect, and they're a pretty easy install.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 22, 2026
S
Verified Purchase
Sean
Waukegan, US
★★★★★ 5
Will buy again!
What a perfect replacement and they fit just right.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 12, 2026

recommand products

Used Behringer Bass Brassmaster Fuzz Pedal w/Box TFW3491 – Tone Shop Guitars
22.86
MAESTRO BRASS MASTER REPLICA COMPLETE KIT – General Guitar Gadgets
23.30
Latent Lemon – Bass Brassmaster – Pedal Markt
24.13
Jim Dunlop DB01B Dimebag Cry Baby From Hell Wah Pedal - Black (DB-01B / DB 01B)
27.48
Dunlop Dimebag Wah Pedal DB01
27.99